could not initialize device naruto что делать
не запускается BeamNG.Drive
N9333305563
Our engine could not initialize a valid DX11 device. Please verify that your video card is DirectX11 compatible.
Перевод.
Нашему движку не удалось инициализировать действующее устройство DX11. Убедитесь, что ваша видеокарта совместима с DirectX11.
N9333305563
Чел как бы в ранних версиях игры была поддержка Directx 10, потом его убрали и оставили только Directx 11, если же у тебя лицуха в стиме то поиграть не получиться, тебе придётся скачивать пиратку версии игры как говорит гугл 0.14.0.5 это последняя поддерживаемая версия Directx 10.
P.S. И ещё раз пишу твоя видяха поддерживает максимум Directx 10.1
UPD. хотя ты можешь поиграть в стиме на Directx 10, короче в стиме на игру ПКМ-свойства-бета и выбираешь версию 0.14.0.5, но учти версия старая нового контента разрабы завозить под Directx 10 и эту версию не будут.
Clint Boessen’s Blog
Lots of Hints, Tips and Tricks for IT Professionals.
Avantgarde Technologies
Tuesday, July 29, 2014
After the EasyCAP dongle arrived in the mail, I installed the Honestech HD DVR 2.5 software which came on the EasyCAP CD shipped with the device. This software is used for recording video coming through the EasyCAP USB dongle and encoding it to a digital format you configure. As for the driver for the EasyCAP DC60 Video Capture Adapter, the CD did not contain any driver files.
Windows 7 64bit automatically scanned its online driver repository for an appropriate driver and ended up detecting the EasyCAP dongle as a «Usbtv007» device. The driver which Windows 7 64bit detected and installed was the incorrect driver and as a result, when attempting to open the Honestech HD DVR 2.5 software the following error was experienced:
Could not initialize the capture device
I spent over an hour on the Internet trolling through dodgy websites attempting to find a driver that works with Windows 7 x64 however none of the drivers downloaded matched the vendor and hardware ID’s of the EasyCAP DC60 Video Capture Adapter which for my model are:
USB\VID_1B71&PID_3002&REV_0100
USB\VID_1B71&PID_3002
To save someone the pain I went through to obtain a working driver for this device, I uploaded the driver which you can download from the following link below:
Note: This ZIP contains both the 32bit and 64bit drivers.
When you install this driver the EasyCAP device will appear in Device Manager as OEM Capture. Make sure you have the above Hardware ID’s on your device before attempting to use this driver which can also be viewed in Device Manager.
Hope this blog post saves someone the pain I went through!